433MHz data link protocol
Posted: 22 May 2023 16:06
Hello,
I have purchased 22 years ago a full set of many piece by Conrad WS2000 comprising 6 temperature/humidity remote data link , a wind sensor and strength, a regenmesser a display and an "funk empfanger" to get all data on my PC. This works fine since 2001 and now the "funk 433MHz empfanger" is often unable to be read by the PC.
I am ready to purchase and settled a 433MHz receiver driven by an arduino to catch all the data send by all my sensors. This in order not to throw away the complete wetterstation.
Is there a description somewhere of the protocol used between the sensors and the "funkempfanger" ?
Many thanks for any advice able to progress in my whish to replace the "funk 433MHz empfanger" !
best regards
JeF
I have purchased 22 years ago a full set of many piece by Conrad WS2000 comprising 6 temperature/humidity remote data link , a wind sensor and strength, a regenmesser a display and an "funk empfanger" to get all data on my PC. This works fine since 2001 and now the "funk 433MHz empfanger" is often unable to be read by the PC.
I am ready to purchase and settled a 433MHz receiver driven by an arduino to catch all the data send by all my sensors. This in order not to throw away the complete wetterstation.
Is there a description somewhere of the protocol used between the sensors and the "funkempfanger" ?
Many thanks for any advice able to progress in my whish to replace the "funk 433MHz empfanger" !
best regards
JeF